Installation; General - Hatco Glo-Ray GR3SDS-DCT Série Manuel D'installation Et D'utilisation

English

General

Glo-Ray Heated Glass Merchandisers are shipped with most
®
components installed and ready for operation. The following
installation instructions must be performed before plugging in
and operating the cabinet.
WARNING
ELECTRIC SHOCK HAZARD: Unit is not weatherproof.
Locate the unit indoors where the ambient air temperature
is a minimum of 70°F (21°C).
FIRE HAZARD: Locate control side of unit a minimum of
3" (76 mm) and all other sides a minimum of 1" (25 mm)
from combustible walls and materials. If safe distances are
not maintained, combustion or discoloration could occur.
CAUTION
Locate unit at the proper counter height in an area that
is convenient for use. The location should be level to
prevent the unit or its contents from falling accidentally
and strong enough to support the weight of the unit and
contents.
NOTICE
Do not lay unit on the side with the control panel or damage
to the unit could occur.
1. Remove the unit from the carton. Two people are required
for this step.
NOTE: To prevent delay in obtaining warranty coverage, complete
online warranty registration. See the IMPORTANT
OWNER INFORMATION section for details.
2. Install the 2-1/2" (64 mm) legs onto the bottom of the unit.
a. Remove the box stop/sign holder on each shelf.
NOTE: The side glass panels are shipped loose. Make sure
they are not installed before tipping unit.
b. Carefully lay unit on its side, and remove the four rubber
shipping feet, if installed. This step requires two people.
NOTE: Place a piece of cardboard between the unit and the
floor to prevent marring the unit finish.
c. Thread the 2-1/2" (64 mm) legs into the hole at each
corner on the bottom of the unit. Hand-tighten the legs
until snug. Do not over-tighten.
d. Return the unit to its upright position. This step requires
two people.
e. Replace the box stop/sign holder on each shelf.
Adjustable
Tip
Lengthen
Installing the Legs
Form No. GR3SDSCTM-1119
Shorten
2-1/2" (64 mm) Leg
3. Remove tape and protective packaging from all surfaces
of unit.
4. Install the glass side panels. To install:
a. Angle the top of the glass panel into the upper channel.
b. Carefully lower the panel into the lower channel.
Glass Side Panel angled slightly.
Installing the Glass Side Panels
5. Place the unit in the desired location.
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70°F
(21°C). Avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods,
air conditioning ducts, and exterior doors).
• Make sure the unit is at the proper counter height in an
area convenient for use.
• Make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• Make sure all the feet on the bottom of the unit are
positioned securely on the countertop.
6. Level the unit by turning the leveling nut on each leg, if
necessary. When looking at the top of the unit, turning the
nut clockwise will lengthen the leg, and turning the nut
counterclockwise will shorten the leg.
7

INSTALLATION