Electric Shock Hazard; Fire Hazard; Important Safety Information - Hatco Glo-Ray GR3SDS-DCT Série Manuel D'installation Et D'utilisation

English
Read the following important safety information before using this equipment to avoid serious
injury or death and to avoid damage to equipment or property.
WARNING

ELECTRIC SHOCK HAZARD:

• Plug unit into a properly grounded electrical receptacle
of the correct voltage, size, and plug configuration. If
plug and receptacle do not match, contact a qualified
electrician to determine and install the proper voltage
and size electrical receptacle.
• Turn OFF power switches, unplug power cord(s), and
allow unit to cool before performing any cleaning,
adjustments, or maintenance.
• This unit has one or two power cords. Disconnect
ALL power supply cords before performing any
maintenance or cleaning.
• DO NOT submerge or saturate with water. Unit is not
waterproof. Do not operate if unit has been submerged
or saturated with water.
• Unit is not weatherproof. Locate unit indoors where the
ambient air temperature is a minimum of 70°F (21°C).
• Do not steam clean or use excessive water on the unit.
• Do not pull unit by power cord.
• Discontinue use if power cord is frayed or worn.
• Do not allow liquids to spill on heated glass shelf.
• Do not clean unit when it is energized or hot.
• This unit is not "jet-proof" construction. Do not use
jet-clean spray to clean this unit.
• Do not attempt to repair or replace a damaged
power cord. The cord must be replaced by Hatco, an
Authorized Hatco Service Agent, or a person with
similar qualifications.
• Use only Genuine Hatco Replacement Parts when
service is required. Failure to use Genuine Hatco
Replacement Parts may subject operators of the
equipment to hazardous electrical voltage, resulting in
electrical shock or burn. Genuine Hatco Replacement
Parts are specified to operate safely in the environments
in which they are used. Some aftermarket or generic
replacement parts do not have the characteristics that
will allow them to operate safely in Hatco equipment.
FIRE HAZARD: Locate control side of unit a minimum of
3" (76 mm) and all other sides a minimum of 1" (25 mm)
from combustible walls and materials. If safe distances are
not maintained, combustion or discoloration could occur.
This unit may have two 120 V circuits, and each circuit
has a separate power cord. Each circuit/power cord must
be plugged into a separate branch circuit rated 120 V and
a minimum of 15 A.
Do not place food product directly onto hardcoat surface.
Food product must be wrapped, boxed, or on a food pan.
Hatco Corporation is not responsible for actual food
product serving temperature. It is the responsibility of the
user to ensure that food product is held and served at a
safe temperature.
This unit is not intended for use by children or persons
with reduced physical, sensory, or mental capabilities.
Ensure proper supervision of children and keep them
away from the unit.
Form No. GR3SDSCTM-1119

IMPORTANT SAFETY INFORMATION

Make sure all operators have been instructed on the safe
and proper use of the unit.
This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to electric
shock or burn.
This unit has no "user-serviceable" parts. If service
is required on this unit, contact an Authorized Hatco
Service Agent or contact the Hatco Service Department at
800-558-0607 or 414-671-6350.
BURN HAZARD:
• Some exterior surfaces on unit will get hot. Use caution
when touching these areas.
• Do not come in contact with heated glass shelf during
operation. Both sides of heated glass shelf are very
hot.
Locate unit at the proper counter height in an area that is
convenient for use. The location should be level to prevent
the unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
The National Sanitation Foundation (NSF) requires that
units over 36" (914 mm) in width or weighing more than
80 lbs. (36 kg) either be sealed to or raised above the
installation surface. If this unit cannot be sealed at the
point of use, 2-1/2" (64 mm) legs are included to allow for
proper cleaning access below the unit.
Do not allow the glass shelf to overheat. Overheating may
cause the food containers to melt or soften.
Do not use food pans, ceramic dishes, or abrasive
materials on heated glass shelf. Scratching of the glass
surface may occur, marring its appearance and making it
susceptible to soil accumulation. Damage to glass surface
or breakage of glass caused by misuse is not covered
under warranty.
Locate in an area that avoids air current around unit.
Avoid areas that may be subject to active air movements
or currents (i.e, near exhaust fans/hoods, exterior doors,
and air conditioning ducts).
Do not lay unit on the side with the control panel or damage
to the unit could occur.
Use non-abrasive cleaners and cloths only. Abrasive
cleaners and cloths could scratch finish of unit, marring its
appearance and making it susceptible to soil accumulation.
3
WARNING
CAUTION
NOTICE