AVG AVC-306CS CAROLINA Instructions D'installation Et Guide De L'usager page 23

INSTALLING THE UNIT
Install 6" round adapter/damper on top of the hood using 4 No. 8 x 7/16" mounting screws.
Align the hood and center it above the hood mounting bracket. Gently lower the hood until it
securely engages the bracket.
With the hood hanging in place, drill through both holes located at the back of the hood using a
5/16" drill bit (see Fig. 2).

Insert the drywall anchors (included) into the drilled holes (one for each hole). Insert 2 No. 8 x
1¼" mounting screws in 2 washers, then insert into the drywall anchors. Verify that the hood is
centered and leveled. Tighten all screws completely.
Remove protective plastic film covering the lower chimney only.
If possible (when space is sufficient), install the lower chimney bracket to the chimney using 2
No. 8 x 7/16" mounting screws ensuring that the slots point up (see Fig. 3).
Carefully place both chimneys on top of the hood.
to avoid damaging it.
Slide a 6" metal round duct over the adapter/damper (see Fig. 2). Use metal foil duct tape to seal
the joint.
Plug hood power cord into the outlet.
Slide up the upper chimney until it is aligned with its mounting bracket. The bracket must be
inside the chimney. Secure the upper chimney to its bracket using 2 No. 8 x 7/16" mounting
screws.
Remove protective plastic film covering the upper chimney and the hood.
Fig. 1
Fig. 3
UPPER
CHIMNEY
MOUNTING
BRACKET
23
NOTE: Slightly slide up the upper chimney
Fig. 2