Operation; Switching On And Off; Adjusting The Rotational Speed - Parkside PWSA 20-Li C3 Traduction Des Instructions D'origine

With thin grinding discs (see fig. 1)
♦ The collar of the clamping nut
so that a thin grinding disc can be fitted safely.
Fig. 1
♦ Press the spindle locking button
motor.
♦ Tighten the clamping nut
mounting spanner
With thick grinding discs (see fig. 2)
Fig. 2
The collar of the clamping nut
so that the grinding disk can be fitted securely onto
the attachment spindle
♦ Lock the attachment spindle
♦ Tighten the clamping nut
direction using the two-hole mounting
spanner .
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must be replaced
immediately.
♦ For safety's sake, run the appliance at maximum
speed for 60 seconds after every disc change.
Be aware of unusual noises and sparks.
♦ Check whether all the fastening elements are
correctly fitted.
PWSA 20-Li C3
faces upwards
≤ 3,2 mm
to lock the
using the two-hole
.
> 3,2 mm
faces downwards
.
.
in a clockwise
♦ Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough
grinding discs (including diamond cutting discs)
and the direction of rotation of the appliance
(arrow showing the direction of rotation on the
head) match.
12

Operation

Switching on and off
Check the attached tool before use to ensure that
all fastening elements are correctly fitted.
NOTE
► Always switch on the angle grinder before
making contact with the material, then apply
it to the workpiece.
Switching on:
♦ First, press the ON/OFF switch
so that you can then press it forwards.
Switching off:
♦ Let go of the ON/OFF switch
Switching to continuous operation:
♦ First, press the ON/OFF switch
so that you can then press it forwards. Then
press the ON/OFF switch
down until it engages.
Switching off continuous operation
♦ Press the ON/OFF switch
downwards and release it.

Adjusting the rotational speed

You can use the adjusting wheel for speed pre-
selection to preselect the rotational speed:
(1 = slower speed, 6 = faster speed).
We recommend you carry out practice tests to
determine the correct speed.
The speed can also be changed during operation.
to the right
.
to the right
forwards and
to the rear and
GB │ IE │ NI │
13 ■