afx light DMX MOVING HEAD 1R 120W Manuel D'utilisation page 5

o No DMX signal
o Screen protect
o Open the lamp
o Restore to default settings
•
MENU setup ( manual control of each DMX channel )
•
SYSTEM setup
o Software version
o DMX monitor : To see DMX information
o System errors : To see fixture errors
o Total fixture hours : To see used time of fixture
o Partial fixture hours
o Total lamp hours : To see used time of lamp
o Partial lamp hours
•
ADVANCED setup
o Sensor monitor
o Reset calibration
o Lamp life hours : to see life time of the lamp
o Lamps hours clear
•
Chinese – English switch
•
Display screen reverse
2.2 Set up the interface
Option
Run Mode
DMX Address
Channel Mode
X Reverse
Y Reverse
X/Y Exchange
No DMX Signal
Display screen protect
Lamp on start up
© Copyright LOTRONIC 2016
instruction
DMX Slave state:Accept control table or main engine
Auto1
Auto2
Master State: Auto running and send DMX signal for Slave
Random auto
Sound control
Press OK key into edit state, Then selected hundreds place. Press up or
down, change address code. Press OK key again, selected ten place
1-512
and edit. Press OK key again, select the first place and edit. Press it to
exit the edit state.
12 12CH Mode
OFF
ON
OFF
ON
OFF
Change the channel of X/Y axis （include X/Y Fine）
ON
KEEP According to the original state continues to run
CLEAR Motor reset, stop running
ON Closing backlight after free 30seconds
OFF Backlight still lighting
Reset directly after Power on , lamp off (need to use the menu or control
OFF
table to manual let lamp light)
BEAM1R Page 5