afx light DMX MOVING HEAD 1R 120W Manuel D'utilisation page 4

The connection between the output of master and input of product, it's available to use the 3 pins XLR cable which
provided by the manufacturer. Signal cable from the DMX output of the controller to the input of the first master light,
and connect to the DMX input of second slave light from the DMX output of the first master light, analogously, till
connected all the slave lights, and insert the last connector to the output of the final light. (Notice: the diameter of
core of every cable should be 0.5mm at least, double core shelter cable should be used).The signal connecting must
use the attached 3 pins XLR cable. Notice, all the internal lead wire of the 3 pins XLR cable should not touch to each
other or connect to the connector.
DMX signal terminator is recommended on the last unit of the chain. DMX terminator is a XLR connector with a
120Ω resistor between the pin 2 and pin 3 of the XLR connector
Features
•
High precision optical lens
•
12 DMX channels
•
12 colors + white
•
11 fixed gobo's + blank
•
Rotating 8-face prism
•
Auto, sound, DMX512 & master-slave mode
•
Linear dimmer 0-100%
•
Electronic ballast
Lamp ......................................................................................................... YODN 1R 120W
Power supply ................................................................................... AC100-240V 50/60Hz
Consumption ............................................................................................................ 120W
Color temperature ..................................................................................................... 8500K
Beam angle ...................................................................................................................... 5°
Pan/Tilt ................................................................................................................ 540°/250°
Dimensions ......................................................................................... 310 x 230 x 390mm
Weight ......................................................................................................................... 9kg
OPERATION
2.1 Press "MODE" to switch the menu
•
SET setup
o Run mode : Choose operating mode ( AUTO / SOUND / DMX / SLAVE )
o DMX address : Set DMX address
o Channel mode
o Lamp control
o Sound sensitive
o X reverse
o Y reverse
o X/Y exchange
© Copyright LOTRONIC 2016 BEAM1R Page 4