Blade Guide - HOLZMANN MASCHINEN HBS 230HQ Mode D'emploi

14.2.4 Blade guide

The blade guide is used to adjust the distance from the band saw blade to the guide bearing.
Do not adjust the sawband guidance when the machine
is working!
Heavy injuries on hands and arms are possible!
Sawband guidance can be adjusted only after the
sawband direction and the sawband tension has been
proofed.
Before you adjust the sawband guidance switch off the
machine and wait until the sawband is standing completely
still.
Upper blade guide
The height of the guide must be adjusted prior to each work so that the saw band about 10 mm
ends to the workpiece.
 The Locking knob loosen and adjust the appropriate level with the Adjusting knob and then
secure again.
 Loosen the screw (A), and adjust guide bearing position, so that guide bearing is
positioned 1or 2mm from teeth of blade. Retighten the bolt (A).
 Loosen the screw (B), and adjust trust bearing to a position of 0.5mm from rear of blade.
Retighten the knob (B).
 Loosen the socket head screw (C), and adjust guide bearing to a position 0.5mm away
from blade. Retighten the socket head screw (C).
HOLZMANN MASCHINEN GmbH
W A R N I N G
www.holzmann-maschinen.at
OPERATION
39
HBS 230HQ