Blade Tension - HOLZMANN MASCHINEN HBS 230HQ Mode D'emploi

Upper cover
Upper cover
Fig. A
After setting and before switch on turn the upper wheel roll by hand a few
times to see if the band saw runs out of the rollers. If this is the case, the
blade must be aligned again.

14.2.3 Blade tension

Too much tension: The band saw blade can break
Too less tension: The band saw blade can slip and stop
The ideal voltage is in the range between worktable and the upper saw band at about 2mm.
If this is not the case, loosen or tighten the bandsaw blade as follows:
 Clamping by turning the knob clockwise.
 Relax by turning it counterclockwise.
After the end of the work shift the saw band is to relax with the quick-release lever again.
Blade tension knob
HOLZMANN MASCHINEN GmbH
Check the blade tension before any operation
www.holzmann-maschinen.at
N O T I C E
W A R N I N G
N O T I C E
OPERATION
Tracking set knob
Fig. B
38
HBS 230HQ