HOLZMANN MASCHINEN HBS 230HQ Mode D'emploi page 36

3. Mounting table assembly
Remove the D-nut, washers, and wing screw on the saw table.
Slide the saw table past the blade and through the slot moving to the frame, pulling the angle
adjustment knob away from the saw frame, Align the teeth on the saw table bracket into the
teeth on the angle adjustment knob. Release the knob.
 Fit the pins on the frame into the slots of the saw table
bracket.
 Assemble the flat washer and table lock handle. Tighten
the saw table to the saw frame by turning the table lock
lever clockwise.
 Attach the D-nut, washers, and wing screw to the saw
table
• Secure the hook with M6 hex nut to the frame.
• Place push stick onto the hook
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
Fix the band saw to a workbench by using four
thread forming screws (not provide)
Place the fence and miter gauge onto the

table.
ASSEMBLY
36
HBS 230HQ