Evolution R185SMS Notice Originale page 31

www.evolutionpowertools.com
MAINTENANCE
Note: Any maintenance must be carried out with
the machine switched off and disconnected from
the mains/battery power supply.
Check that all safety features and guards operating
correctly on a regular basis.
Only use this machine if all guards/safety features
are fully operational.
All motor bearings in this machine are lubricated
for life. No further lubrication is required.
Use a clean, slightly damp cloth to clean
the plastic parts of the machine. Do not use
solvents or similar products which could damage
the plastic parts.
WARNING: Do not attempt to clean by inserting
pointed objects through openings in the
machines casings etc.
The machines air vents should be cleaned using
compressed dry air.
EN
Excessive sparking may indicate the presence of
dirt in the motor or worn out carbon brushes. If
this is suspected have the machine serviced and
the brushes replaced by a qualified technician.
ENVIRONMENTAL PROTECTION
(6.4)
Waste electrical products should not be disposed
of with household waste. Please recycle where
facilities exist. Check with your Local Authority or
retailer for recycling advice.
31