English; General Instructions; Installation Instructions - Pentair T2QuickNet Manuel D'installation

T2QUICKNET

ENGLISH

General instructions

Pentair Thermal Management offers a 12 year Total Care
Warranty for this product. Please check the Total Care
Warranty Certificate and Registration Form (included in the
Commissioning form or downloadable from
www.raychemfloorheating.com) for more details. Please read
the complete installation instructions carefully. Pay attention to local
circumstances, standards and regulations. The commissioning form has
to be filled out by a qualified electrician. It should be kept by the owner
of the building in order to comply with electrical regulations and the
Total Care Warranty conditions.

Installation instructions

T2QuickNet may not be cut to length, crossed or installed closer than
the spacing of cables pre-installed on the mat. T2QuickNet can be
installed under floor tiles or natural stone. The thermal resistance of the
floor construction above T2QuickNet should be as low as possible (Max.
0,15 m² K/W). Do not step on the mats during installation. Avoid sharp
objects and incautious pouring of concrete/filler. No airgaps are allowed
in the concrete/filler. Also the heating mat should not be laid across
expansion joints. The joint between the heating cable and the connection
cable must be located in the filler (grout) and must not be pulled up into
the conduit. Handle the joint with care. i.e. do not bent or pull the joint.
Always pay attention to instructions for the floor covering adhesive.
T2QuickNet shall be installed in min. 5 mm of concrete/filler. Do not lay
heating cable in areas that might be damaged by drilling etc. or might
be covered by cupboards etc. It is not allowed to place T2QuickNet under
a heat source such as a stove etc. The subfloor should be clean, plain,
stable and rigid, without cracks, sharp objects or adhesion-reducing
substances. Cracks are to be filled out on beforehand with a casting
resin. Big roughness is to be levelled out. The concrete subfloor must
be completely dry before installing the floor heating system. With
quickly solidifying plaster, one should follow the supplier's instructions.
T2QuickNet can be fixed, if required, to the subfloor by means of glue
or staples.
Fixing with staples is only allowed in the net, and never over the heating
cable.
6