PROEL M1622USB Notice D'utilisation page 21

82. +48V phantom switch and LED
This switch ac vates (LED on) and deac vates (LED off ) the phantom power on MIC Inputs. Most professional condenser
microphones require phantom power, which is a lower DC voltage delivered to the microphone on pin 2 and 3 of the
XLR microphone connector. Dynamic microphones do not require phantom power, however phantom power will not
harm most dynamic microphones should you plug one in while the phantom power is on. Check the manual of your
microphone to fi nd out for sure whether or not phantom power can damage it.
83. ON led
Indicates when the mixer is switched on.
84. POWER switch
Make sure that all master output knobs are turned all the way down when powering your mixer up or down.
85. AC~ socket
Here's where you plug in your mixer's mains supply cord. You should always use the mains cord supplied with the mixer.
Be sure your mixer is turned off before you plug the mains supply cord into an electrical outlet.
86. FUSE holder
Here is placed the mains protec on fuse. Please follow the instruc ons on page 10 of this manual to replace it.
87. PRODUCT LABEL
In this label are wri en the most important informa on about the mixer, model, line voltage, consump on, serial
number.
21