Set-Up And Operation - EUROM RAD 2000 Oilfree Wifi Manuel D'utilisation

 Unscrew the 4 screws on the bottom of the stove, attach the two wheel supports
to the stove and screw these supports tightly, see illustration.
 Return the heater to its upright position, wheels down.
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
Warning: only use the heater when it is in an upright position, with the
wheels attached to the bottom (as pictured on the front of this booklet).
Any other position is dangerous!

Set-up and operation

 Push the plug into an earthed socket.
 Press the ON/OFF switch to start the heater; the heater will make a beep sound
once. The display shows
 Press the WiFi/Standby button
heater setting:
- Ambient temperature 20°C
- Timer off
- Heating level: H3 (2000W)
 To switch off, press the WiFi/Standby button and the heater will
stop operating. Now take out the plug from the socket.
 Note: The heater always starts at the standard heater settings.
 Note: A radiator cools down slowly. Therefore, give it sufficient
time before you touch it or move it (use the handle!).
Setting the temperature
 Turn the MODE button to the desired temperature setting
between 5°C and 35°C. Clockwise increases the temperature, counter clockwise
decreases the temperature.
 If you turn the MODE button completely counter clockwise, the temperature
drops to under 5°C. The heater now stands in the frost protection mode. The
display shows
Setting the heating capacity
 Press the MODE button once and subsequently turn it counter clockwise for
setting the heating capacity:
.
.
to switch to the standard
32