Cleaning And Care; Ceramic; Hob Surround; Rectifying Faults - NEFF T1D83 Série Mode D'emploi

Cleaning and care

The information in this section provides help on how best to
care for your hob.
Suitable maintenance and cleaning products can be purchased
from the after-sales service or in our e-Shop.

Ceramic

Clean the hob after each use. This will prevent spills from
burning onto the ceramic.
Only clean the hob when it has cooled down sufficiently.
Use only cleaning agents which are suitable for glass ceramic.
Follow the cleaning instructions on the packaging.
Never use:
Undiluted washing-up liquid
■
Detergent intended for dishwashers
■
Scouring agents
■
Harsh cleaning agents such as oven spray or stain remover
■

Rectifying faults

Faults often have simple explanations. Please read the notes in
the table before calling the after­sales service.
The electronics of your hob are underneath the control panel.
For various reasons, the temperature in this area may rise
sharply.
Display Fault
Blank There is no power supply.
All displays flash The touch controls are wet or an object is
resting on them.
Several hotplates have been used over a
"ƒ
prolonged period at high power settings.
To protect the electronics, the hotplate
has been switched off.
Despite the switch-off by
"...
tronics have become hot again. All hot-
plates have therefore been switched off.
Warning: There is a hot pan in the area of
and the heat set-
"†
the control panel. There is a risk that the
ting flash alternately.
electronics will overheat.
An audible signal
can be heard
There is a hot pan in the area of the con-
and audible sig-
"†
trol panel. To protect the electronics, the
nal
hotplate has been switched off.
The hotplate was in operation for too long
"‰
and has switched itself off.
34
Abrasive sponges
■
High-pressure cleaners or steam jet cleaners
■
Ground-in dirt can be best removed with a glass scraper,
available from retailers. Please note the manufacturer's
instructions.
You can also obtain a suitable glass scraper from our after-
sales service or from the e-Shop.
Using special sponges to clean glass ceramic achieves great
cleaning results.

Hob surround

To prevent damage to the hob surround, observe the following
instructions:
Use only hot soapy water.
■
Wash new sponge cloths thoroughly before use.
■
Do not use any sharp or abrasive agents.
■
Do not use the glass scraper.
■
In order that the electronics do not overheat, the hotplates are
switched off as and when necessary. The
display appears alternately with the
indicator.
Measure
Check the household fuse for the appliance. Check whether
there is a power cut by trying other electronic appliances.
Dry the touch controls or remove the object.
Wait a while. Touch any touch control. When
electronics have cooled down sufficiently. You can continue
cooking.
, the elec- Wait a while. Touch any touch control. When
"ƒ
can continue cooking.
Remove the pan. The fault display goes out shortly afterwards.
You can continue cooking.
Remove the pan. Wait a while. Touch any touch control. When
goes out, you can continue cooking.
"†
You can switch the hotplate back on again immediately.
"ƒ , "... , or "†
• or œ residual heat
goes out, the
"ƒ
goes out, you
"...