Before Using The Cooktop For The First Time; Induction Cooktop Operation; Important - Fulgor Milano Sofia 30 Guide D'utilisation Et D'entretien

Before using the cooktop for the first time

• All products are wiped clean with solvents at the factory to
remove any visible signs of dirt, oil, and grease which may
have remained from the manufacturing process.
• Clean your glass top before the first time you use it. A
thorough cleaning with a glass top cleaner is recommended.
It only takes a minute and puts a clean, shiny coating on the
glass top before its initial use.
• There may be a slight odour during the first several uses: this
is normal and will disappear.
• Optimum cooking result depends on the proper cookware
being selected and used.
• The cooking surface will hold the heat and remain hot over
20 minutes after the elements have been turned off.
• The glass ceramic cooking surface is a durable material
resistant to impact but not unbreakable if a pan or other
object is dropped on it.
• Do nor allow pans to boil dry. This can damage the pan,
element and /or cooktop.
• Do not slide cookware across cooking surface it may scratch
the glass
• Using cast iron cookware on the glass cooktop Is not
recommended. Cast iron retains heat and may result in
cooktop damage.
Power Sharing
One generator controls 2 elements, or two cooking zones
within a heating section share the power of one generator.
Power Sharing is activated when both elements in the same
cooking zone are activated and one element is set for Boost
(P). The element that is not set for Boost will change to a lower
power level. This is called Power Sharing: The latest set cooking
level has priority.
INDUCTION

28 - Induction Cooktop Operation

IMPORTANT

Automatic Switch OFF
The induction hob has an automatic device which limits the
duration of use.
Depending on the chosen cooking level a maximum
operation time limitation is defined, the safety device will be
activated only if no change of cooking level is done. If this
maximum operating time is exceeded on a cooking zone
this cooking zone is being switched off, a short beep sounds
and if the zone is hot the "residual heat" symbol is showed.
In order to reactivate this cooking zone the control knob has
to be turned back into OFF position.
IMPORTANT
Overheating status of cooking zone
If the hob is used on full power for a long period, the
electronics could have trouble cooling down if the room
temperature is high. To avoid excessively high temperatures
forming in the electronics, the power to the cooking zone is
managed automatically to protect itself.
Permanent use of keys
FAULT MESSAGE
If the knobs have been kept rotated in the "A" or "P" positions
for more than 30 seconds a fault message will appear on the
display.
Cookware "noise"
When using adjacent elements that are set at certain power
level settings, magnetic fields may interact and produce a low
whistle or intermitted "hum". Pans that completely cover the
element ring will produce less noise. A low "humming" noise
is normal particularly on high settings. These noise can be
reduced or eliminated by lowering or raising the power level
settings of one or both of the elements.
EN
37