What To Do If - ZANKER KDT10012FK Notice D'utilisation

What to do if...

The start of the appliance does not occur or it stops
during operation.
First try to find a solution to the problem (refer to the
table). If not, contact the service centre.
• The programme indicator flashes continuously.
• The end indicator flashes one time intermittently.
• The programme indicator flashes continuously.
• The end indicator flashes two times intermittently.
• The programme indicator flashes continuously.
• The end indicator flashes three times intermittently.
Warning! Deactivate the appliance before you do
the checks.
Malfunction
The appliance does not fill with wa-
ter.
The appliance does not drain the
water.
The anti-flood device is on.
The start of the washing pro-
gramme does not occur.
26
Alarm code
Possible cause
The water tap is blocked or there is
limescale on it.
The water pressure is too low.
The water tap is closed.
The filter in the water inlet hose is
blocked.
The connection of the water inlet
hose is not correct.
The water inlet hose is damaged.
There is a blockage in the sink spi-
got.
The connection of the water drain
hose is not correct.
The water drain hose is damaged.
The appliance door is open.
The mains plug is not connected in
the mains socket.
With some malfunctions the indicators flash to
show an alarm code.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
Clean the water tap.
Contact your local water authority.
Open the water tap.
Clean the filter.
Make sure that the connection is
correct.
Make sure that the water inlet hose
has no damages.
Clean the sink spigot.
Make sure that the connection is
correct.
Make sure that the water drain
hose has no damages.
Close the water tap and contact the
service centre.
Close the appliance door.
Connect the mains plug.
Malfunction
Possible solution