ZANKER KDT10012FK Notice D'utilisation page 27

Masquer les pouces Voir aussi pour KDT10012FK:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Malfunction
After the check, activate the appliance. The programme
continues from the point of interruption.
If the malfunction occurs again, contact the service cen-
tre.
If the different alarm codes show, contact the service
centre.
The necessary information for the service centre is on
the rating plate.
The washing results and drying results are not satisfactory
Problem
The dishes are not clean.
Limescale particles on the dishes.
There are streaks, milky stains, or a
bluish layer on glasses and dishes.
Possible cause
The fuse in the fuse box is dam-
aged.
The delay start is set.
Record this information:
– Model (MOD.) ........................................................
– Product number (PNC) ..........................................
– Serial number (S.N.) ..............................................
Possible cause
The selected washing programme
was not applicable for the type of
load and soil.
The baskets were not loaded cor-
rectly, water did not touch all surfa-
ces.
The spray arms could not turn free-
ly because of incorrect arrange-
ment of the load.
The filters are dirty or not assem-
bled and installed correctly.
The quantity of detergent was not
sufficient or missing.
The salt container is empty.
Incorrect water softener adjustment
The salt container cap is not closed
correctly.
Rinse aid dosage is too high.
Possible solution
Replace the fuse.
• Cancel the delay start.
• When the countdown is comple-
ted, the washing programme
starts automatically.
Possible solution
Make sure that the washing pro-
gramme is applicable for the type of
load and soil.
Load the baskets correctly.
Make sure that an incorrect ar-
rangement of the load does not
cause a blockage of the spray
arms.
Make sure that the filters are clean
and correctly assembled and instal-
led.
Make sure that the quantity of de-
tergent is sufficient.
Fill the salt container with dishwash-
er salt.
Adjust the water softener.
Make sure that the salt container
cap is closed correctly.
Decrease the rinse aid dosage.
27

Publicité

Table des Matières
loading

Table des Matières