Care And Cleaning - ZANKER KDT10012FK Notice D'utilisation

2. Press and hold the programme button until the pro-
gramme indicator goes off and the end indicator
starts to flash.
Make sure that there is detergent in the detergent
dispenser before you start a new washing pro-
gramme.
End of the washing programme
When the washing programme is completed, an inter-
mittent acoustic signals sounds.
1. Open the appliance door.
• The end indicator is on.
2. Deactivate the appliance.

Care and cleaning

To remove and clean the filters
Dirty filters decrease the washing results.
1
3
To remove filters B and
C, turn the handle ap-
proximately 1/4 counter-
clockwise .
C
B
A
2
Clean the filters below
running water.
A
4
Remove the flat filter A
from the bottom of the
appliance.
For better drying results, keep the appliance door
ajar for some minutes.
Remove the items from the baskets
• Let the dishes become cold before you remove them
from the appliance. Hot dishes can be easily dam-
aged.
• First remove the items from the lower basket, then
from the upper basket.
• There can be water on the sides and on the door of
the appliance. Stainless steel becomes cool more
quickly than the dishes.
D
A
5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clogged, remove
remaining parts of soil with a thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance and con-
trol panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads
or solvents (acetone).
6
Put the filter system in
position. To lock the filter
system, turn the handle
clockwise until it locks in
position.
25