ZANKER KDT10012FK Notice D'utilisation page 19

1) When the salt container is empty, the related indicator does not come on while a washing programme operates.
On/off button
Press this button to activate or deactivate the appli-
ance.
Programme indicators A and B
These indicators have also an auxiliary function when
you:
• Adjust the level of the water softener.
• Activate or deactivate the acoustic signals.
Programme button
With this button you can:
• Set a washing programme.
• Adjust the level of the water softener.
• Activate or deactivate the acoustic signals.
• Cancel a washing programme in operation.
Delay start button
Press this button to delay the start of the washing pro-
gramme of three hours. Refer to 'Setting and starting a
washing programme'.
Setting mode
The appliance must be in setting mode for these
operations:
• To set and start a washing programme.
• To adjust electronically the level of the water soften-
er.
• To deactivate or activate the acoustic signals.
Activate the appliance. The appliance is in setting
mode when:
• All the programme indicators are off.
End indicator. It comes on in these conditions:
• When the washing programme is completed.
• When you adjust the level of the water softener.
• When you deactivate or activate the acoustic signals.
• When the appliance has a malfunction.
Rinse aid indicator. It comes on when it is necessary to fill the rinse aid dispenser.
Salt indicator. It comes on when it is necessary to fill the salt container.
After you fill the container, the salt indicator can stay on for some hours. This does not
have an unwanted effect on the operation of the appliance.
Indicators
• The end indicator flashes.
Activate the appliance. The appliance is not in
setting mode when:
• Only one programme indicator comes on.
– It is necessary to cancel the programme to go
back to the setting mode. Refer to 'Setting and
starting a washing programme'.
Acoustic signals
You can hear the acoustic signals in these conditions:
• The washing programme is completed.
• The appliance has a malfunction.
Factory setting: on.
Deactivating the acoustic signals:
1. Activate the appliance.
2. Make sure that the appliance is in setting mode.
3. Press and hold the programme button until the pro-
gramme indicator (A) flashes and the programme
indicator (B) comes on.
4. Press immediately the programme button again.
The programme indicator (A) comes on and the
programme indicator (B) starts to flash.
After some seconds, the programme indicator (A)
goes off and the end indicator comes on. The pro-
gramme indicator (B) continues to flash.
5. Press the programme button again, the end indica-
tor goes off. The acoustic signals are deactivated.
6. Deactivate the appliance to confirm.
1)
1)
19