What To Do If - ZANKER KDI 10000 Notice D'utilisation

1
3
To remove filters B and
C, turn the handle ap-
proximately 1/4 counter-
clockwise .

What to do if...

The start of the appliance does not occur or it stops
during operation.
First try to find a solution to the problem (refer to the
table). If not, contact the service centre.
• The start/cancel indicator flashes continuously.
• The end indicator flashes one time intermittently.
• The start/cancel indicator flashes continuously.
• The end indicator flashes two times intermittently.
• The start/cancel indicator flashes continuously.
• The end indicator flashes three times intermittently.
Warning! Deactivate the appliance before you do
the checks.
2
Clean the filters below
running water.
4
Remove the flat filter A
from the bottom of the
appliance.
Alarm code
5
Put the flat filter A in the
bottom of the appliance.
Install the flat filter cor-
rectly under the two
guides D.
To clean the spray arms
Do not remove the spray arms.
If the holes in the spray arms become clogged, remove
remaining parts of soil with a thin pointed object.
To clean the external surfaces
Clean the external surfaces of the appliance and con-
trol panel with a moist soft cloth.
Only use neutral detergents.
Do not use abrasive products, abrasive cleaning pads
or solvents (acetone).
With some malfunctions the indicators flash to
show an alarm code.
The appliance does not fill with water.
The appliance does not drain the water.
The anti-flood device is on.
6
Put the filter system in
position. To lock the filter
system, turn the handle
clockwise until it locks in
position.
Malfunction
25