Symbols On The Scooter; Transport - Vermeiren Ceres SE Manuel D'utilisation

In case a serious incident has occurred involving your product, notify Vermeiren or your specialist
dealer as well as the competent authority in your country.
2.3

Symbols on the scooter

The symbols in following list are applicable for your scooter. Missing symbols can be found in the
relevant ISO standard (ISO 7000, ISO 7001 and IEC 417).
2.4

Transport

2.4.1 Moving the scooter
The best way to carry the scooter is to make use of the neutral mode. Place the scooter in neutral
and roll the scooter to the desired place.
If this is not possible, you can carry the scooter according to the following steps:
1. Switch the scooter off.
2. Remove loose parts (seat and batteries).
3. Store loose parts in a safe place.
4. Carry the frame + steering unit with 2 or 3 persons to the desired place. Hold the frame to
the chassis or fixed parts of the frame, not the bumpers or the plastic parts.
2.4.2 Transport in the car
DANGER
WARNING
 Remove all loose parts prior to transportation.
 No people or objects should be under the scooter, on the footplate or seat during transportation.
 Make sure that the scooter is attached properly to avoid injury of the passengers during
collision or sudden braking.
 Do not place fingers between the components of the scooter.
The best way to transport your scooter in the car is to drive the scooter in the car using ramps.
Maximum weight of the user
Outdoor use
Indoor use (battery charger only)
Maximum safe slope in °
Maximum speed
Type designation
Risk of entrapment
Risk of injury - The scooter is not suited for use as a seat in a motor
vehicle.
Risk of injury
5
EN
Ceres SE
2021-08
Before use
NL