Automatic Power Shutdown - Vermeiren Ceres SE Manuel D'utilisation

EN
NL
3.5.3 Adjusting the backrest
1 = Seat system
2 = Tilt lever
1
3.5.4 Adjusting the headrest:
1. Gently press the locking pin (1) toward the headrest.
2. Move the headrest to the desired height.
3. Let go of the locking pin (1).
4. The headrest audibly locks into place.
3.5.5 Adjusting the armrests
CAUTION
 Make sure that the armrests are positioned symmetrically from the seat.
 Always mount the inner tube on a safe distance of 50 mm in the outer tube.
The armrest can be adjusted in width.
3.6

Automatic power shutdown

In order to avoid accidental battery rundown, your scooter is equipped with an automatic power
shutdown facility. If the scooter is switched on and remains undisturbed for a period of ten
minutes, it will automatically turn off. Should this occur, simply switch your scooter off and back
on and it will be ready to use again.
A tilt lever (2) has been added to the side of the
backrest (transition to seat upholstery). Pull this lever
upwards to release the backrest and fold the
backrest forward (-75°), or adjust the angle of the
backrest (0°-22°).
2
1
Risk of tipping over
1. Remove the star knob on the back of the scooter.
2. Grasp the inner square tube.
3. Move the tube to adjust the armrest to the desired width
(range: 55 mm each side, 4 positions).
4. Retighten the star knob.
5. Make sure that the armrest is well secured.
1 = Locking pin
12
Ceres SE
2021-08
Using your scooter