SCS Sentinel SG2 Notice D'utilisation Et D'installation page 27

RF-Learn
D7- LED indication
SYS-Learn
LED1
LED2
LED3
LED4
OFF ON
SW1:Set
1. D/S set
2. Over_C1
ELECTRONIC CARD
3. Over_C2
4. Auto
5. Ph
NONE
D8- Remote controls learning process
Press "RF-learn" button for 2 seconds, and the LED1 will be on; then press the transmitter top left button, then top right
button. The LED1 will blink twice and stay on for 10 seconds then be off. And the remote memorize has completed.
D9- System learning process for double leaf gate
The remote control memory storing operation must be over before starting the final system learning
process.
RX
The LED2 light will remain ON until the system learning process is not over. Let your gate totally opened. Press
«SYS-learn» (until the LED2 light begins to flash once every second, instead of twice every second as it normally
would), then press the upper-left key for a double gate.
photocellules
The system learning process will be as follows, step by step:
1
4
After step 6, the system learning process is complete. You can use it with the remote control:
double gate full opening
1
LED 1 System Learning:
LED1 will be on when remote controls are activated.
LED 2 System learning:
LED 2 blinks twice per second during normal operation and once per
second during learning. Static LED2 means incorrect programming.
LED 3 Photocells:
LED 3 will be on when photocells are not aligned or when there's an
obstacle in between.
LED4 start :
LED 4 will be on if the switch of the transmitter, key selector, or the push
button is activated.
1 2 3 4 5 6
TX
sélecteur
à clé
2
5
2
7 8 9 10
bouton feu
poussoir clignotant
24V 10W
3
6
pedestrian opening (single gate)
3
FI
Fusible T20A
250V
11 12 13 14
serrure
M1
12/24V
EN
M2
27