Installation Of The Appliance; Control Panel - Olimpia splendid AQUARIA 18 P Instructions Pour L'installation, L'emploi Et L'entretien

1.3 - INSTALLATION OF THE APPLIANCE

• After removing the packaging, check that the appliance is in perfect condition; in case of doubts do not use it and
refer to professionally qualified personnel.
• Install the appliance on a rigid and levelled floor while keeping the room ventilated.
• Place the appliance in a suitable environment.
Make sure that curtains or other objects don-t obstruct the air flow (Fig. 5).
• Leave at least 20cm of free space on both sides and behind the appliance and leave at least 30cm of free space
above it (Fig. 1).
• Remove the tank (7) and uncoil the supply cord (9).
• Correctly reposition the tank (7) in the appliance body.
• Insert the plug in the power socket; the appliance emits a "beep".

1.4 - CONTROL PANEL

ON/OFF key
Press this key to start the appliance.
Press it again to switch the appliance off (the fan still works for 1 minute, then it stops).
Voltage presence led
This led turns on in green when the appliance is running.
Water tank full led
When the water tank is full, the led turns on in red, the appliance stops and the buzzer sounds
20 times to warn the user.
It is necessary to remove the tank (7) (figure 7) and to empty it.
Correctly reposition the tank in order to restart the appliance.
Timer key
With the appliance electrically powered but not running
press the "TIMER" key to enter the function, then press key "-" or "+" once or more times to set
the start delay time (from 1 to 24 hours), the led TIMER blinks in green.
When the value set on the display stops flashing, the value is saved and the led switches
steady on. When the set time finishes, the appliance starts working.
To deactivate the function before the appliance start up,set the TIMER time to "00", switch the
appliance on or off.
EN - 17