Oven Care And Cleaning; Self-Cleaning The Oven; Preparing The Oven For Self-Clean - BORETTI BPZN 60 Notice D'emploi

Abrasive detergents and steam cleaning equipment should not
be used for cleaning.
WARNING
Do not use harsh abrasive cleaners or sharp metal scrapers
to clean the oven door glass since they can scratch the
surface, which may result in shattering of the glass.
WARNING
Ensure that the door is in the closed position before the self-
cleaning cycle starts, otherwise automatic door locking will
not be completed. See paragraphs that follows.

Self-Cleaning the Oven

This oven features a pyrolytic self-cleaning function that
eliminates the difficult and time consuming manual scrubbing
of the oven interior. During self-cleaning, the oven uses a very
high temperature (approx. 860°F/460°C) to burn away food
soil and grease.
• It is common to see smoke and/or an occasional flame-up
during the Self-Clean cycle, depending on the content and
amount of soil remaining in the oven. If a flame persists, turn
off the oven and allow it to cool before opening the door to
wipe up the excessive food soil.
• The door latch is automatically activated after selecting the
Self-Clean cycle. The "PADLOCK" icon will appear in the
display. This ensures that the door cannot be opened while
Hand clean frame
area ouside gasket
DO NOT
hand clean gasket
Hand clean door
area outside gasket

18 - Oven Care and Cleaning

the oven interior is at clean temperatures.
• The oven light does not operate during this mode.
• During Self-Clean, the kitchen should be well ventilated to
help eliminate odors associated with Self-Clean. Odors will
lessen with use.
• Three hours is the preset length of cleaning.
• The mode automatically stops at the end of the clean hours.
• When the oven heat drops to a safe temperature, the
automatic door lock will release and the door can be
opened.

Preparing the Oven for Self-Clean

1. Remove all utensils and bake ware.
2. Remove non-porcelain oven racks. If chromed racks are left
in the oven during the self-clean cycle, they will permanently
lose the shiny finish and change to a dull dark finish.
3. Wipe up any soft soil spills and grease with paper towels.
Excess grease will cause flames and smoke inside the oven
during self-cleaning.
4. Review illustration below. Some areas of the oven must be
cleaned by hand before the cycle begins. They do not get
hot enough during the cleaning cycle for soil to burn away.
Use a soapy sponge or plastic scrubber. Hand-clean the
oven door edge, oven front frame and up to 1-½ " (2-3 cm)
inside the frame with detergent and hot water. Do not rub
the gasket on oven. Clean by hand the oven door window.
Rinse all areas thoroughly then dry.
5. Be sure oven interior lights are turned off and the light bulbs
and lens covers are in place.
Hand clean 1" (2cm)
from rack guides
to frame of oven cavity
Hand clean door
window
EN
29