Setting The Bus Address On Devices Without Rotary Switch For Setting The Address; Setting The Bus Address On Devices With Rotary Switch For Setting The Address (Types 8718 / 8708) - Burkert 8718 Manuel D'utilisation

7.5.1. setting the bus address on devices without rotary switch
for setting the address
The bus address of the devices can be set either via the Bürkert configuration tool "Mass Flow Communicator" in
"Views" → PROFIBUS / DeviceNet / CANopen or directly via the bus master.
When an address has been changed, it must be re-initialised on the slave and on the master. In doing so, it is
necessary, depending on the bus, to send a corresponding telegram.
Recommendation:
To ensure a trouble-free setting, the device should be reset.
(Disconnect the device from the power supply).
7.5.2. setting the bus address on devices with rotary switch for
setting the address (Types 8718 / 8708)
When the device is switched on, the address set with the rotary switches is accepted as a slave address.
Valid addresses are: • PROFIBUS
If the address was set outside the permitted range, the address setting has the validity as described in Chapter 7.5.1. .
Fig. 10: Setting the bus address on devices with rotary switch (Types 8718 / 8708)
If an address setting is required using the available rotary switches via the bus master, this can be
implemented by setting an address outside the valid range.
A change to the bus address via the rotary switches does not become effective until the device is
restarted.
30
0 – 126
• DeviceNet 0 – 63
• CANopen 1 – 127
lsB
Unit position (x 1)
MsB
Tens position
(x 10)
The address is composed of LSB + MSB
Example:
address
1
63
100
127
english
Type 8718, 8719 / 8708, 8709
Installation and Start-up
Unit position Digit times 1
0 – 9
Tens position Digit times 10
0 – 9
A
B
C
D
E
F
MsB setting lsB setting
0 1
6 3
A 0
C 7
0 – 9
0 – 90
100
110
120
130
140
150