EUROM RAD 2000T Manuel D'utilisation page 37

Set-up and operation
 Set the ON/OFF switch to 0 (off) and the thermostat button to MAX.
 Fully insert the plug into the socket. When doing so, completely unwind the flex.
The RAD 1500, 2000 and 2000T lamp will now light up.
RAD 500:
 Set the ON/OFF switch to 1 (on); the lamp will burn and the heater will start
working.
RAD 1500 / 2000 / 2000T:
 Operate the heater by setting the power switch to 1, 2 or 3. The heater will now
operate at 600, 900 or 1500 W respectively (RAD 1500) or 800, 1250 or 2000 W
respectively (RAD 2000 and 2000T). To heat up slowly, for a slight temperature
increase or in a small space, select position 1; For heating up fast, for a larger
temperature increase or in a larger space, select position 2 or 3.
Thermostat RAD 500
Turning the thermostat knob fully to 'min' will retain a temperature of 5°C in the
space (as long as the area is not too big or too cold), this is the frost protection
functionality.
Thermostat RAD 1500/2000/2000T):
Once the space has reached the right temperature, turn the thermostat dial to MIN
until you hear a click. If you leave the dial in this position, the heater will maintain
the current temperature by regularly switching on and off. By turning the thermostat
dial to the MAX / MIN, you increase/decrease the set temperature. If so desired, you
can now switch to a lower power level.
Turbo RAD2000T:
The RAD 2000T is fitted with an extra ceramic heating element (400W) with an
integral fan that can blow warm air into the room. Activate this Turbo by pressing
the turbo switch on (I) the lamp lights. Stop it by pressing the turbo switch off (0);
the lamp extinguishes.
 To switch off, turn the power switch to off (O). The heater switches off. Unplug.
 Note! It takes a long time for an oil filled radiator to cool down. Give the radiator
sufficient time to cool down before touching or moving (use handle!).
Safety features
The heater is fitted with a tipping safeguard which automatically shuts off the
appliance if it inadvertently falls over. When the heater is returned to its upright
position, it will resume functioning as normal but, before reusing, switch off, unplug
and check for damage. Do not use the heater if it is damaged or malfunctioning, but
have it inspected/repaired!
37