EUROM RAD 2000T Manuel D'utilisation page 36

Installation, Location and Connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
before it has been installed in accordance with the following instructions!
RAD 500:
Firmly slide the legs supplied over the front panel or the
second last fin, as illustrated.
RAD 1500 en RAD 2000:
 Screw the 2 x 2 swivel castors with the 4 capped nuts
onto the ends of the two wheel supports. The wheels should be at the hollow side!

Turn the radiator upside-down (make sure you don't scratch the paint or the floor!)
 Remove the wing nuts from the U-shaped bolts.
 Then mount the U-shaped bolts left and right between the outer fins.
 Slide the wheel supports with wheels over the ends of the U-shaped bolt, so that
the wheels are as far as possible mounted.
 Now tighten the wing nuts tightly onto the ends of the U-shaped bolt, but not so
tight as to damage the oil-filled fins.
 Return the heater to its upright position, wheels down.
Warning: only use the heater when it is in an upright position, with the
wheels (c.q. feet) attached to the bottom (as pictured on the front of this
 Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
 Check that the socket used is earthed and that it matches the power specified on
the heater's type plate.
Do not use the heater
manual). Any other position is dangerous!
36