Publicité
Les langues disponibles
Les langues disponibles
ATTENTION!
Keep your workplace clean and tidy. Disorder at
the workplace and on the work-table increases risk
of accident and injury.
Pay attention to conditions of environment you
are working in. Do not use electric tools and
devices in a humid or wet environment. Ensure
sufficient lighting. Do not expose electric tools to rain
or high air humidity. Do not switch the electric tools
on in environments with flammable liquids or
inflammable gases.
Do not allow unauthorised persons to get to the
machine. Keep visitors and spectators, especially
children and handicapped persons, in a safety
distance from your workplace.
Ensure safe storage of tools. Tools and equipment
you do not need must be stored at an elevated
place, if possible, so that they were not accessible to
unauthorised persons.
Always use correct equipment for all works.
Do not use e.g. small tools or accessories for works
that need to be executed by heavy equipment. Use
tools solely for purposes for which they have been
designed. Do not overburden the device!
Pay attention to the electric cable.
Do not pull the cable. Pull the connector plug only
when pulling out of socket. Protect the cable against
heat sources, oil and sharp edges.
Prevent from unintentional switching on.
Make always sure the switch on the device was in
the off position before connector plug is plugged in.
Use special extension cables at outdoor works.
For outdoor works you need special extension
cables suitable for such works and with appropriate
marking.
Stay concentrated at all times. Pay attention to
what you are doing.
Use common sense. Do not use the electric
equipment when you are tired.
Pay attention to damaged parts. Check the device
before use. Are any parts damaged? In case of
small damage please consider whether the device is
really capable of perfect and safe working.
Protect yourself against electric shocks.
Prevent any contact of your body with earthed
objects, e.g. water piping, heating elements, cookers
and fridges.
Use approved parts only. Always use only identical
spare parts at maintenance and repairs. Spare parts
are available in an authorised service centre.
Warning!
Any use of accessories and extensions not explicitly
recommended in these operating instructions may
result in a threat to persons and objects.
Safety Instructions for First Putting the Machine into
Operation
The appliance meets EN 61000-3-11 requirements
and is subject to special connection conditions. That
means that use on optionally selected connection
points is inadmissible.
The appliance can lead to occasional voltage
fluctuations under unfavourable power conditions.
The appliance is only designated to be used for connection
points not exceeding the maximum allowed impedance of
Z
= 0,233 Ω.
max
As a user, you must make sure your connection point on
which you want to use the appliance meets the above-
mentioned requirements – after agreement with your
electricity supplier if necessary.
Always pull the connector plug out of socket before machine
adjustment or maintenance.
Children are prohibited to operate the machine.
After packing removal check whether the device and all its
parts are in a perfect condition.
Always wear protective glasses and hearing protection
aids
Always wear protective glasses and corresponding sight and
hearing protection aids. Never aim with compressed air
beam at your body or other persons or animals. Impurity
may be accelerated to a great extent by air flow and thus
become a dangerous shot.
Always use protective equipment against electric shock
Never use the compressor near water or in a humid
environment.
Put properly the compressor out of operation
Disconnect the compressor from power source and release
all pressure from the air jet before repair, inspection,
maintenance, cleaning or replacement of construction parts.
Unintentional switching on
Do not transfer the compressor when connected to power
source or when the air jet is under pressure. Before
connecting the compressor to power source make sure the
pressure transducer switch is in the OFF position.
Proper compressor storage
When the compressor is not in use it is necessary to
disconnect it from power source, store it at a dry place
protected against climatic influences. Keep it out of reach of
children.
Working clothes
Do not wear wide clothes or jewellery as they can get caught
by machine parts.
Careful compressor maintenance
It is necessary to follow the lubrication instructions (see
the throat for oil adding and oil level inspection in the
"Handling" chapter).
It is necessary to follow instructions concerning
protective cover in the air filter described in the
"Handling" chapter.
Check regularly the power cord. If damaged it needs to be
repaired or replaced in the service repair centre. Make sure
there is no outer visible damage of the compressor. In case
of need, please contact the nearest repair centre.
Outdoor use
If use the compressor outside it is allowed to use extension
cables designed for outdoor use and with appropriate
marking only.
Attention: It is necessary to use a cable with sufficient
cross section (min. of 1.5 mm
m there may be starting problems at unfavourable
temperatures.
Attention
Work considerately and use common sense. Do not use the
compressor if you are tired, impaired or intoxicated with
drugs causing tiredness.
2
); at cables longer than 10
Publicité
