Agilent Technologies TwisTorr 84 FS AG Mode D'emploi page 278

17 Technical Information
Profibus Option
15 1 mBar/Torr/P
a
16 1
17 1 mBar/Torr/P
a
18 1
19 1
278/297
0-99 Setpoint 1 Pressure Value Mantissa.
Set the mantissa of the exponential value of the R1
setpoint (format X.XE-XX) when it is used for
pressure monitoring (Parameter Buffer, Offset 21,
B = 4). The value set here is divided by 10, that
0-2
means 11 = 1.1
-10 - +10 Setpoint 1 Pressure Value Exponent.
Set the exponent of the exponential value of the R1
setpoint (format X.XE-XX) when it is used for
pressure monitoring (Parameter Buffer, Offset 21,
B = 4).
0-2
0-99 Setpoint 2 Pressure Value Mantissa.
Set the mantissa of the exponential value of the R2
setpoint (format X.XE-XX) when it is used for
pressure monitoring (Parameter Buffer, Offset 21,
B = 4). The value set here is divided by 10, that
3-5
means 11 = 1.1
-10 - +10 Setpoint 2 Pressure Value Exponent.
Set the exponent of the exponential value of the R2
setpoint (format X.XE-XX) when it is used for
pressure monitoring (Parameter Buffer, Offset 21,
B = 4).
3-5
B = Stop Speed Reading.
0
This function measures the pump speed after a stop
command.
0 = Off
1 = On
B = Active Stop.
1
This function brakes the pump after a stop
command, by using the motor as a generator.
0 = Off
1 = On
B - Reserved
2
B = Start/Stop/Interlock Mode.
3-4
Change the logic of Start/Stop and Interlock inputs.
Ask to Agilent personnel for this option
TwisTorr 84 FS AG Rack Controller User Manual / 87-901-037-01 (A)
162
162
176
176
167
107
151