Tunturi Pure Cross F 8.1 Mode D'emploi page 6

• Fit front stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step B
• Fit height adjustment pads to the rear
stabilizer.
• Fit rear stabilizer by using the shown
hardware.
Remark:
First put all screws/ bolts in correct place
before tightening them fully.
Assembly step C
• Fix height adjustment pads to the
U shape rail
• Fix U shape rail with the rear
stabilizer.
Remark:
First tighten all 4 bolts hand tight before
tightening them fully. This to avoid miss
alignment
6
Assembly step D
• Connect the wires from upright tube
and main frame before sliding the
upright tube in position.
Remark:
Do not remove screws from the frame
before siding the upright tube in position.
• Use the enclosed Allen key to tighten
both fastening screws through the
holes in the tube from inside out.
• Tighten the fastening screws by
turning them counter-clockwise.
Remark:
First tighten all 6 bolts hand tight before
tightening them fully. This to avoid miss
alignment
Assembly step E
• Stabilize the upright tube as shown
in picture.