AVG AVN-308CS2-NEVADA Instructions D'installation Et Guide De L'usager page 26

PREPARATION BEFORE HOOD INSTALLATION
You may Choose between 1 or the 3 venting proposed options ; TOP 6" ROUND , TOP 3 1/4" X 10" OR
REAR 3 1/4" X 10". Due to the weight and size of the hood, at least two (2) people are required to move
and install the hood safely.
OPTION 1 : 6" ROUND/TOP EXHAUST
As shown on figure 1 the 6" round/top exhaust is already pre-installed for venting.
OPTION 2 : 3-1/4" X 10" TOP-RECTANGULAR INSTALLATION :
1. Remove the pre-installed Round Exhaust (Refer to Figure 1). Keep 6 screws aside as you ill ned
them to install the Rectangular Exhaust.
2. Place the rectangular 3-1/4" X 10" Exhaust Plate over the opening and secure using
the previously mentioned screws (Refer to Figure 2).
Figure 1
OPTION # 3 : 3-1/4" X 10" REAR - RECTANGULAR INSTALLATION
1. Remove the pre-installed Round Exhaust (Refer to Figure 1).
2. Remove the Rear Vent Cover (image 3). Keep cover and screws as they
will be needed later in the process.
3. Remove the 4 screws that secure the blower/motor. Hold the blower and try
and keep it from dropping as you remove screws. Keep screws to re-attach
blower afterwards. Slowly rotate blower (1/4 turn) and align it with mounting
plate (image 4) located at the rear exhaust hole. Using the rectangular plate
(image 4) securely screw the blower into its new position facing the rear
exhaust opening (Refer to Figure 4).
Figure 2
26
IMAGE 4