Checking The Automatic Oil System; Adjusting The Telescopic Handle; Adjusting The Handle; Adjusting The Cutting Angle - Parkside PAHE 20-Li C3 Traduction Des Instructions D'origine

Checking the automatic oil system

Before starting work, check the window for the oil
level and the automatic oil system.
♦ Switch the appliance on and hold it over a
lightly coloured floor surface. The appliance
must not touch the ground.
♦ If there is an oil trace, the appliance is opera-
ting correctly.
♦ If there is no oil trace, clean the oil dispenser
or have the appliance repaired by our Customer
Service.
♦ To clean, wipe the residues from the oil
dispenser using a brush or cloth.

Adjusting the telescopic handle

The telescopic handle
ously by means of the quick release
♦ Activate the quick release
the length by pushing or pulling as required.
♦ Close the quick release
the desired working length of the telescopic
handle .
♦ If the screw of the quick release
ened, tighten it again with a hex key.

Adjusting the handle

♦ Undo the screw on the handle
handle can be moved.
♦ Set the handle in the desired position.
♦ Retighten the screw on the handle
PAHE 20-Li C3
can be adjusted continu-
.
and adjust
again, thereby fixing
has loos-
until the
3a
.
3a

Adjusting the cutting angle

NOTE
► The cutting angle can be adjusted in 3 stages.
♦ Remove the battery pack
♦ Press the release button
♦ Adjust the angle of the motor unit to the required
position.
♦ Let go of the release button
unit will click into place.
♦ Insert the battery pack
ance.

Sawing techniques

WARNING!
► Pay attention to falling clippings.
► Be aware of the danger of branches flying
back.
NOTE
► Place the stop
you work more safely and quietly.
► Now you can begin with the sawing.
Sawing off small branches
♦ Saw small branches (Ø 0–8 cm) from the top
down (see figure).
from the appliance.
.
and the motor
back into the appli-
on the branch. This will help
GB │ IE │
13 ■