Polar Refrigeration GL180 Mode D'emploi page 7

Fault
The appliance turns on,
but the temperature is
too high/low
The appliance is
leaking water
The appliance is
unusually loud
Technical Specifications
Model Voltage Power Current
GL180 230V 50Hz 350W
GL181
230V 50Hz 750W
GL180-GL181_ML_A5_v6_170602.indb 7
Probable Cause
Too much ice on the evaporator
Condenser blocked with dust
Doors are not shut properly
Appliance is located near a
heat source or air flow to the
condenser is being interrupted
Ambient temperature is too high
Unsuitable foodstuffs are being
stored in the appliance
Appliance is overloaded
The appliance is not properly
levelled
The discharge outlet is blocked
Movement of water to the drain is
obstructed
The water container is damaged
The drip tray is overflowing
The safety band has not been
removed
Loose nut/screw
The appliance has not been
installed in a level or stable
position
Temperature
Range
1.95A 2°C to 8°C
3.5A -22°C to -18°C
Solution
Defrost the appliance
Clean the Condenser
Check doors are shut and seals are not
damaged
Move the refrigerator to a more suitable
location
Increase ventilation or move appliance to a
cooler position
Remove any excessive hot foodstuffs or
blockages to the fan
Reduce the amount of food stored in the
appliance
Adjust the screw feet to level the appliance
(if applicable)
Clear the discharge outlet
Clear the floor of the appliance (if
applicable)
Call POLAR agent or qualified Technician
Empty the drip tray (if applicable)
Remove the safety band
Check and tighten all nuts and screws
Check installation position and change if
necessary
Capacity Dimensions
Refrigerant
(litres) H x W x D mm
850 R290 95g 2010 x 740 x 900
850 R290 90g 2010 x 740 x 900
UK
Weight
(kg)
161
170
7
2017/6/2 16:04