Polar Refrigeration GL180 Mode D'emploi page 4

UK
Pack Contents
The following is included:
• POLAR Refrigerator or Freezer
• Keys x 2
• Shelf guides x 10
• Instruction manual
POLAR prides itself on quality and service, ensuring
that at the time of packaging the contents are
supplied fully functional and free of damage.
Should you find any damage as a result of transit,
please contact your POLAR dealer immediately.
Installation
Note: If the unit has not been
stored or moved in an upright
position, let it stand upright for
approximately 12 hours before
operation. If in doubt allow to
stand.
1. Remove the appliance from the packaging.
Make sure that all protective plastic film and
coatings are thoroughly removed from all
surfaces.
2. Maintain a distance of 20cm (7 inches)
between the unit and walls or other objects for
ventilation. NEVER LOCATE NEXT TO OR
NEAR A HEAT SOURCE.
Note: Before using the appliance
for the first time, clean the
shelves and interior with soapy
water.
3. Set the brakes on the castors to keep the
appliance in position
OR
Level the appliance by adjusting the screw
feet.
4
GL180-GL181_ML_A5_v6_170602.indb 4
Removing the Compressor Safety
Band
• The compressor is located on the top of the
appliance, and sits on rubber washers. Under
normal operating conditions the compressor is
allowed to vibrate.
• To avoid damage through excessive motion
during transit, a stainless steel safety band is
placed over the compressor and screwed into
the top of the appliance.
• This safety band and the two screws fixing it
to the appliance must be removed before the
appliance is turned on.
Lock/Unlock the Doors
A lock is fitted to the doors to ensure foodstuffs
are kept secure within your POLAR appliance.
Use the keys provided to lock/unlock the doors.
Fitting the Waste Water Tray
The waste water tray comes ready to fit to the
underside of the appliance.
Slide the tray into the runners situated under the
appliance.
Compressor
Safety Band
Compressor
Screws
2017/6/2 16:04