EUROM CONVECTOR Panel de Luxe Manuel D'utilisation page 17

Using for the first time and Operation
1. Control light 'heater on'
2. Control light 'low output'
3. Control light 'high output'
4. Control light heating
5. Thermostat symbol
6. Button for selecting low/high output
 Check to make sure the main switch is set to O (off).
 Check that the heater is stable and upright, in line with instructions.
 Now insert the plug into the 220/240V socket.
 Set the main switch to I (on). The control light 'heater on' (POWER) lights up.
 Now press the activation button (7). The display will show room temperature and
the set output (LO=low, HI=high).
 At the factory, the thermostat is set to 35°C, the timer to 00.00.
Setting temperature
 Press the activation button again; the display will show a blinking '35' and '°C'.
 Press the 'higher' or 'lower' button to set the desired temperature: every time you
press the button, the set temperature will increase/decrease by 1 degree. The
temperature can be set between 5 and 45°C. Once the desired temperate
appears on the display, you can stop. The set temperature will blink for 5 seconds
on the display, then the room temperature will be displayed again. The thermostat
is now set and the thermostat symbol (°C) will be lit up. Once the heater begins to
heat, the Heating control light (4) will light up; it goes out when the heater shuts
down.
Setting timer
 Press on the activation button twice. The display will blink '0' (or the set hours)
and the timer symbol.
 Press the 'higher' or 'lower' button to set the length of time you would like the unit
to work: every time you press the button, the set time will increase/decrease by 1
hour. The time can be set from 0 to 24 hours. Once the desired time appears on
the display, you can stop. The set time will blink for 5 seconds on the display,
then the room temperature will be displayed again. The timer is now set and the
heater will start to work. The timer symbol remains lit up for the set period. Once
the set period is up, the heater will switch off (without providing a signal).
 The set period can be amended while the heater is on by pressing twice on the
activation button and repeating the procedure. The heater then forgets the old
setting and applies the newly programmed time.
Selecting output
 Pressing the high/low selection button (6) while the heater is on, switches from
high (HI) to low (LO) output or the other way around.
7. Activation button
8. Display
9. Timer symbol
10. 'Higher' button
11. 'Lower' button
12. Main switch
17