Description
1. Heat outlet grille
2. Air inlet grille
3. Swivel wheels (x4)
4. Operation panel
5. Main switch
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact your
vendor for inspection or replacement.
Do not use the heater before it has been installed in accordance with the
This heater may not be used while suspended!!!
Composition and Installation
Attach the feet supplied to the underside of the heater (see picture):
Turn the heater upside down. Place a blanket (or something similar) under the
heater to prevent damage!
Push both feet (each with 2 swivel
wheels) into the recesses on the base of
the heater until you hear them click into
place.
In order to remove the feet, push the
clamp (A) in; you can now remove the
foot.
Return the heater to the upright position.
Make sure a working heater is always placed on a solid, flat and horizontal
surface. Deep-pile carpeting is unsuitable!
following instructions!
16