EUROM Ultimate 2000 Manuel D'utilisation page 16

25. The appliance (incl. cord and plug) may only be opened and/or repaired by
properly authorised and qualified persons.
26. Only use this heater for its intended purpose and as described in this instruction
manual.
Not abiding by instructions 24, 25 & 26 may lead to damage, fire and/or personal
injuries. A failure to adhere to these rules also immediately nullifies the guarantee
and vendor, importer and/or manufacturer do not take responsibility for any of the
consequences!
Description
Location and Connection

Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.

Choose a suitable location for the heater which is at least one metre away from
any obstructions, walls or inflammable materials (see also safety instructions).

Make sure a functioning heater is always placed on a solid, flat and horizontal
surface.

Check if the control dial is set to 'OFF' (O).

Fully extend the power cord and plug into a suitable 220-240V socket. To
prevent the circuit overloading, check that no other appliances are connected to
the same group.
Set-up and Operation

Turn the thermostat dial to maximum (clockwise as far as possible).

Switch the heater on by turning the control dial to one of the following three
positions:
Fan only (thermostat always to maximum)
I
Heating at half power (1000W)
II
Heating at full power (2000W)
1 – control dial
2 – thermostat dial
3 – pilot light
4 – handle (reverse side)
5 – air outlet grill
6 – air intake grill (reverse side)
7 – oscillating function switch (reverse side)
8 – oscillating foot
16