Zanussi ZBB24430SA Notice D'utilisation page 23

x
x
1
If necessary cut the
adhesive sealing strip and
then apply it to the appli-
ance as shown in figure.
4mm
44mm
3
Adjust the appliance in
the niche.
Make sure that the dis-
tance between the appli-
ance and the cupboard
front-edge is 44 mm.
The lower hinge cover (in
the accessories bag)
makes sure that the dis-
tance between the appli-
ance and the kitchen furni-
ture is correct.
Make sure that the clear-
ance between the appli-
ance and the cupboard is
4 mm.
Open the door. Put the
lower hinge cover in posi-
tion.
2
1
2
Install the appliance in
the niche.
Push the appliance in the
direction of the arrows (1)
until the upper gap cover
stops against the kitchen
furniture.
Push the appliance in the
direction of the arrows (2)
against the cupboard on
the opposite side of the
hinge.
I
I
4
Attach the appliance to
the niche with 4 screws.
5
Remove the correct
part from the hinge cover
(E). Make sure to remove
the part DX, in the case of
right hinge, SX in opposite
case.
G
H
7
Connect the appliance
laterally to the kitchen fur-
niture sidewall:
1. Loosen the screws of
the part (G) and
move the part (G) till
the furniture side-
wall.
2. Tighten the screws of
the part (G) again.
3. Attach the part (H) to
the part (G).
~50 mm
o
90
21 mm
90 o
~50 mm
21 mm
9
Install the part (Ha) on
the inner side of the kitch-
en furniture.
C
D
E
E
B
6
Attach the covers (C,
D) to the lugs and the
hinge holes.
Install the vent grille (B).
Attach the hinge covers (E)
to the hinge.
Ha Hb
Hc Hd
8
Disconnect the parts
(Ha), (Hb), (Hc) and (Hd).
Ha
Hc
10
Push the part (Hc) on
the part (Ha).
23