AERMEC FCXI P Série Manuel D'utilisation Et D'installation page 20

ROTATING THE COIL
If the hydraulic connections require the
rotation of the coil, remove the front
closure panel and proceed as follows:
- Remove the condensate drip tray;
- Undo the screws and remove the coil
cover;
- Remove the screws securing the coil,
then remove the coil;
- Remove the push-outs on the right-
hand side;
- Rotate the coil and secure it with the
previously removed screws;
- Reassemble the cover and fix it with
the screws;
- Reassemble the plastic plugs (supplied)
in the holes left free by the water
connections;
- All the trays can be used to collect
condensate on both sides. In case of
vertical installation, to discharge
condensate on the right side, position
the drain connection to the right;
- Slide out the electrical wirings from the
right-hand side, remove the push-out
and move the cable grommet from the
right to the left side;
- Transfer the electrical wirings to the left
side through the cable grommet;
- Move the control board, the earthing
u-bolt and any electric devices to the
left-hand side.
IFCXIPLJ 1203 - 5383900_04
20
180°
B
A