AERMEC FCXI P Série Manuel D'utilisation Et D'installation page 18

INSTALLING THE UNIT
To install the unit, proceed as follows:
- remove the air filter;
- Remove the front closure panel;
- For wall mounting, maintain a mini-
mum distance of 80mm from the floor;
- For floor mounting (using feet), refer
to the instructions supplied with the
accessory;
- For wall or ceiling mounting, use wall
plugs (not supplied).
When using the Support accessory (AMP
accessory), proceed as follows:
- assemble the 4 supports at the sides of
the device, inserting the hole in the
special slit and fixing the lower part
to the component by means of the
screws supplied;
WATER CONNECTIONS
- Make the water connections.
- In the event of disassembly and
reinstallation, use new gaskets.
Refer to the size data for the position, type
and diameter of the water connections.
You are advised to adequately insulate
water lines and/or fit the auxiliary
condensate drain tray (available as an
CONDENSATE DISCHARGE
In the event of horizontal installation,
assemble the condensate discharge
connection supplied. Make sure you
seal the connection between the
drip tray and the fitting with silicone.
The condensate drain network must
be properly scaled and the piping
situated in such a way as to keep an
adequate slope along the route (min.
1%). If condensate is discharged into
IFCXIPLJ 1203 - 5383900_04
18
- Fix the flanges to the ceiling, using wall
plugs (not supplied); for the relative
positions between the flanges and the
component, refer to the size data.
Make the water connections as descri-
bed in the relative chapter.
Make the condensate discharge con-
nection as described in the relative
chapter. The fan coils that work in heat
mode only do not require condensate
discharge.
Make the electrical wiring as shown in
the relative chapter and in the wiring
diagrams.
Install and connect any accessories.
accessory), to prevent dripping during
the cooling function.
After installing, check the seal on the
connections.
the sewage system, install a siphon to
prevent the return of unpleasant odours
into the room.
Carry out a functioning and seal test
of the condensate drain system by
pouring water into the tray.
Complete the installation by reassem-
bling the front panel and air filter.
Start up the fan coil and check all the
components and functions are opera-
ting correctly.
2
1
B B
A
A
Ø est. 20,5mm
AMP
B
A