Maintenance And Cleaning; Declaration Of Conformity - stayer RO150E Instructions D'emploi

Sanding Surfaces
Only flawless sanding sheets produce good sanding
performance and protects the machine.
Switch on the machine, place the complete sanding
plate on the surface to be worked and move the ma-
chine over the work piece with moderate pressure.
Ensure uniform sanding pressure. Less sanding pres-
sure increases the sanding capacity and protects the
machine and the sanding tool.
The removal performance and the sanding pattern is
determined essentially by the choice of sanding sheet
(grain), the selected speed, the operating mode and
the application pressure.
Rough Sanding
Attach a sanding sheet with coarse grain
Apply only light pressure to the machine so that it runs
at high speed and high material removal is achieved.
Fine Sanding
Attach a sanding sheet with fine grain
By lightly varying the application pressure or changing
the speed setting, the sanding plate speed can be re-
duced whereby the eccentric movement is retained.
With moderate pressure, move the machine in a circu-
lar pattern or alternately in lengthwise and crosswise
directions over the work piece.
Do not tilt the machine to avoid sanding through the
work piece (e.g. when sanding veneer).
After finishing the work, switch off the machine and lift
it from the work piece.
Polishing
For the polishing of weathered paint or buffing out of
scratches (e.g., Acrylic glass), the machine can be
equipped with appropriate tools such as a lamb's wool
bonnet, polishing felt or sponge (optional accessories).
When polishing with high speed, take care that
the polished surface does not become exces-
sively warm.
For polishing, the vacuuming adapter 4 can be re-
moved to make the machine easier to handle and to
prevent damage to the work piece
Apply polishing agent crosswise or in a circular motion
with a sponge and moderate pressure and then allow
to dry lightly.
Polish the partially dried polishing agent with cross-
wise or circular motions using a lamb's wool polishing
bonnet.
Cleaning the polishing tools.
Clean the polishing tools regularly to ensure good pol-
ishing results.
ENGLISH
12
It is recommended to wash the polishing tools with a
mild detergent and warm water (do not use paint thin-
ning agents).

Maintenance and Cleaning

Before any work on the machine itself, pull the
mains plug.
Always keep the machine and the ventilation slots
clean for proper and safe working.
WARNING
Important instructions for connecting a new 3-
pin plug to the 2-wire cable.
The wires in the cable are coloured according to the
following code:
Strain relief
Live = brown
Neutral = blue
Do not connect the blue or brown wire to the earth ter-
minal of the plug.
Important: If the plug on the cable of this machine
must be replaced, dispose of the old plug to prevent
misuse.
Disposal
Power tools, accessories, and packaging should be
disposed of for recycling in an environmentally friendly
manner.
Only for EU countries
Do not dispose of power tools in
household waste!
According to the European Guide Lines
2002/96/EC, for waste electric and
electronic equipment and its imple-
mentation into national law, power
tools that are no longer usable
must be collected separately and recycled
environmentally friendly manner.

Declaration of Conformity

We declare under our sole responsibility that this prod-
uct is in conformity with the following standards or
standardization documents:
EN 60745-1, EN 60745-2-4, EN 55014-1, EN 55014-2,
EN 61000-3-2, EN 61000-3-3, according to the
provisions of the directives 2014/30/EU.
12
To be fitted
by qualified
professionals only
Ramiro de la Fuente
Director Manager
January, 2017