– damage due to untimely or inadequate
maintenance or damage due to
maintenance or repair work not
performed in the workshops of
specialist dealers.
16. Environmental protection
Lawn clippings should be
composted and not disposed of
in household waste.
The machine, its packaging and
accessories are all produced
from recyclable materials and must be
disposed of accordingly.
By disposing of materials separately, and
in an environmentally friendly manner,
valuable resources can be re-used. For
this reason, the machine should be
disposed of for recycling at the end of its
useful life. Pay particular attention to the
information in the "Disposal" section
during disposal (
4.12).
Consult your recycling centre or your
specialist dealer for information on the
proper disposal of waste products.
Always dispose of batteries
properly – observe local
regulations. Do not dispose of
batteries with domestic waste,
but hand it in to a specialist
dealer or at a hazardous waste collection
point.
17. Standard spare parts
Mowing blade for RMA 443, RMA 443 C,
RMA 443 PC, RMA 443 TC:
6338 702 0130
0478 131 9940 C - EN
Mowing blade for RMA 448 PC,
RMA 448 TC:
6358 702 0115
Blade fastening screw for RMA 443,
RMA 443 C, RMA 443 PC, RMA 443 TC:
9007 319 9024
Blade fastening screw for RMA 448 PC,
RMA 448 TC:
9007 319 9024
Retaining washer:
0000 702 6600
The blade fastening screw and
retaining washer must be replaced
when replacing or installing the
blade. Spare parts are available
from a STIHL specialist dealer.
18. EU - Declaration of
conformity
18.1 Lawn mower, manually operated
and battery-powered (STIHL RMA)
STIHL Tirol GmbH
Hans Peter Stihl-Strasse 5
6336 Langkampfen
Austria
declares under our sole responsibility that
the machine
lawn mower, manually operated and
battery-powered (STIHL RMA)
manufacturer's
STIHL
mark
serial number
6338
type
RMA 443.0
RMA 443.0 C
RMA 443.0 PC
RMA 443.0 TC
manufacturer's
STIHL
mark
serial number
6358
type
RMA 448.0 PC
RMA 448.0 TC
conforms to the following EC directives:
2000/14/EC, 2014/30/EU, 2006/42/EC,
2006/66/EC, 2011/65/EU
The products have been developed in
compliance with the following standards:
EN 60335-1, EN 60335-2-29, EN 60335-
2-77, EN 55014-1, EN 55014-2
The versions of the standards valid on the
production date apply to development and
production of the products.
Applicable conformity assessment
procedure:
Appendix VIII (2000/14/EC)
Name and address of relevant, named
location:
TÜV Rheinland LGA Products GmbH
Tillystraße 2
D-90431 Nürnberg
Compilation and storage of technical
documentation:
Sven Zimmermann
STIHL Tirol GmbH
The year of manufacture and machine
number appear on the rating plate of the
machine.
RMA 443.0:
Measured sound power level:
91,2 dB(A)
59