EUROM 360448 Manuel D'utilisation page 29

Attachment swivel wheels
Attach the feet supplied to the underside of the heater (see
picture):
Turn the heater upside down. Place a blanket (or something

similar) under the heater to prevent damage!
Push both feet (each with 2 swivel wheels) into the recesses on

the base of the heater until you hear them click into place.
Return the heater to the upright position.

Set-up and operation
1. Control light 'heater on'
2. Control light 'low output'
3. Control light 'high output'
4. Control light heating
5. Thermostat symbol
6. Button for selecting low/high
output
 Check to make sure the main switch is set to O (off).
 Check that the heater is stable and upright, in line with instructions.
 Now insert the plug into the 220/240V socket.
 Set the main switch to I (on). The control light 'heater on' (POWER) lights up.
 Now press the activation button (7). The display will show room temperature
and the set output (LO=low, HI=high).
 At the factory, the thermostat is set to 35°C, the timer to 00.00 and output on
"HI"=high.
Setting temperature
 Press the activation button again; the display will show a blinking '35' and '°C'.
 Press the 'higher' or 'lower' button to set the desired temperature: every time
you press the button, the set temperature will increase/decrease by 1 degree.
The temperature can be set between 5 and 45°C. Once the desired temperate
appears on the display, you can stop. The set temperature will blink for 5
seconds on the display, then the room temperature will be displayed again. The
thermostat is now set and the thermostat symbol (°C) will be lit up. Once the
heater begins to heat, the Heating control light (4) will light up; it goes out when
the heater shuts down.
7. Activation button
8. Display
9. Timer symbol
10. 'Higher' button
11. 'Lower' button
12. Main switch
29