EUROM CK501R Manuel D'utilisation page 30

 To use the heater, the feet, delivered separately
in the package, must be mounted on the
heater. The feet should be attached to the base
of the heater using the 4 self-tapping screws.
Make sure they are correctly positioned at the
bottom of the heater.
Set-up and operation
 The frost shield is now ready to use. Insert the plug into a suitable 220-240V-
50Hz grounded socket to switch on the heater. Only connect the heater to an
earthed socket!
 To set the desired temperature, turn the thermostat dial to maximum (biggest
dot, or clockwise as far as it goes). Wait for the desired temperature to be
reached and then slowly turn the knob until the pilot light goes off. The desired
temperature is now set; when the temperature in the immediate vicinity drops
to under this level the heater will switch on, as will the light. To set the
temperature to a higher or lower level, turn the thermostat dial to either
'maximum' (biggest dot) or 'minimum' (star).
 Turning the thermostat dial to 'minimum' (star) means that the frost shield will
keep the area frost-free (as long as the area is not too big or too cold).
 The appliance will function even when set to the lowest level. To fully switch off
the heater, you must remove the plug from the socket.
Safety features
Overheating protection
In case of internal overheating, the overheating protection will switch the heater
off. This may occur if the heater cannot give off enough heat or cannot draw in
enough fresh air. As mentioned above, this is generally caused by (partially)
covering the heater, obstructing the air intake and/or outlet grills or installing the
heater too close to a wall or something similar. In case of overheating, turn off the
heater, unplug and allow the heater to cool down. Once the reason for the
overheating has been removed or amended, you can use the heater again as usual.
If the cause of overheating is unclear and/or overheating occurs regularly, stop
using the appliance and take it to a qualified professional for repair and/or
inspection. Once the heater has been turned off and allowed to cool down after
overheating, it is also possible that it will resume its function automatically. This
does not mean, however, that the cause of overheating has been rectified. If the
heater repeatedly switches on and off due to overheating, this may pose a fire risk
so make sure this does not occur!
30