Kenwood DNX Série Manuel D'installation page 4

Connection
Connector A
Ground wire (Black)
Battery wire (Yellow)
8 6 4 2
7 5 3 1
Ignition wire (Red)
8 6 4 2
7 5 3 1
Connector B
⁄
Connect to the vehicle's parking brake
detection switch harness.
Parking sensor wire (Light Green)
Connect to vehicle's reverse lamp harness when
Connect to the terminal that is grounded when either
⁄
To connect the Kenwood navigation system,
consult your navigation manual.
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
⁄
4
DNX SERIES
(Orange/White)
PRK SW
For the sake of safety, be sure to connect the parking sensor.
using the optional rear view camera.
To steering remote
⁄
To use the steering wheel remote control feature, you need to an
exclusive remote adapter (not supplied) matches your car is required.
When this terminal is not in use, leave its cap on.
the telephone rings or during conversation.
If no connections are made, do not let the cable come out from the tab.
FM/AM antenna
Antenna Cord
input (JASO)
Dimmer control wire (Orange/White)
ILLUMI