Select And Start A Washing Programme - Pelgrim GVW567RVS Notice D'utilisation

Activate/deactivate the ''Multitab func-
tion'' before the start of a washing pro-
gramme.
Once the programme is running, the
"Multitab function " can NO longer be
changed. If you want to cancel the "Mul-
titab function " you have to cancel the
programme setting and then deactivate
the ''Multitab function''. In this case you
have to set a washing programme (and
desired options) again.
Activation/deactivation of the multitab
function
Simultaneously press and hold the two mul-
titab buttons (function buttons D and E) until
the multitab indicator light comes on. This
means that the function is active.
To deactivate the function press the same
buttons again until the indicator light corre-
sponding to the multitab function symbol
goes off.
If the drying results are not satisfac-
tory we suggest that you:
1. Fill up the rinse aid dispenser with
rinse aid.
2. Activate the rinse aid dispenser.
3. Set the rinse aid dosage to position
2.
• The activation/deactivation of the
rinse aid is only possible with the mul-
titab function active.
Activation/deactivation of the rinse aid
dispenser
1. Press the On/Off button. The dishwasher
must be in setting mode.

Select and start a washing programme

Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
2. Simultaneously press and hold function
buttons B and C , until the lights of func-
tion buttons A , B , and C start flashing.
3. Press function button B , the lights of
function buttons A and C go off while the
light of function button B continues to
flash.
4. To activate the rinse aid dispenser, press
button B again, the End indicator light
comes on, indicating that the rinse aid
dispenser has been activated.
5. To memorize the operation, switch off the
dishwasher by pressing the On/Off but-
ton.
6. To deactivate the rinse aid dispenser
again, follow the above instructions until
the End indicator light goes off.
If you decide to revert back to the
use of individual detergents we ad-
vise that you:
1. Deactivate the Multitab function.
2. Fill up the salt container and the rinse
aid dispenser again.
3. Adjust the water hardness setting to
the highest setting and perform 1
normal washing programme without
loading any dishes.
4. Adjust the water hardness setting
according to the hardness of the wa-
ter in your area.
5. Adjust the rinse aid dosage.
4. Press the button corresponding to the re-
quired programme (see ''Washing pro-
grammes'' chart). The indicator light of
the selected programme comes on.
Close the dishwasher door, the pro-
gramme starts automatically.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the indicator light corresponding to the
chosen hours flashes (3h or 6h).
81