Select And Start A Washing Programme - Pelgrim GVW557RVS Notice D'utilisation

Select and start a washing programme

Select the washing programme and
delay start with the door slightly
opened. The start of the programme
or the countdown of the delay start
will occur only after the closure of
the door. Until then it is possible to
modify the settings
1. Check that the baskets have been loaded
correctly and that the spray arms are free
to rotate.
2. Check that the water tap is opened.
3. Press the On/Off button. The dishwasher
must be in setting mode.
4. Press the button corresponding to the re-
quired programme (see ''Washing pro-
grammes'' chart). The indicator light of
the selected programme comes on.
Close the dishwasher door, the pro-
gramme starts automatically.
Setting and starting the programme with
delay start
1. After having selected the washing pro-
gramme, press the delay start button until
the indicator light corresponding to the
chosen hours flashes (3h, 6h or 9h).
2. Close the dishwasher door, the count-
down starts automatically.
3. The countdown will decrease with steps
of 3 hours.
4. Once the delay start has elapsed the pro-
gramme will start automatically.
The opening of the door will interrupt the
countdown. Close the door; the count-
4. Close the lid and press until it locks in
place.
Detergent tablets from different manu-
facturers dissolve at different rates. For
this reason, some detergent tablets do
not attain their full cleaning power during
short washing programmes. Therefore,
please use long washing programmes
when using detergent tablets, to ensure
the complete removal of detergent re-
siduals.
down will continue from the point at
which it was interrupted.
Warning! Interrupt or cancel a
washing programme in progress
ONLY if it's absolutely necessary.
Attention! Hot steam may escape
when the door is opened. Open the
door carefully.
Interrupt a washing programme in
progress
• Open the dishwasher door; the pro-
gramme will stop. Close the door; the pro-
gramme will start from the point at which
it was interrupted.
Cancel a delay start or a washing
programme in progress
• Simultaneously press and hold the two
function buttons B and C until all the pro-
gramme lights come on.
• Cancelling a delay start will also cancel the
washing programme. You have to select
the washing programme again.
• If a new washing programme is to be se-
lected, check that there is detergent in the
detergent dispenser.
End of the washing programme
• The dishwasher will automatically stop and
an audible signal informs you of the end of
the washing programme.
1. Open the dishwasher door.
– The End indicator light is on.
– The indicator light of the programme
just ended remains on.
75