Tristar AC-5495 Manuel D'utilisation page 8

Drainage
During cooling of hot air, condensation can be created. Much of the condensation will be
transported with the warm air outside. At high humidity not all the condense will be transported
with the warm air to the outside, the water tank must regularly be emptied.
If the condensation tank is full, the water full indicator light on the control panel (No. 1) will light
and a sound goes off, the machine stops automatically. The condensate tank has a maximum
capacity of 1.7 liter.
Turn the knob condensate drain (No. 9) off the spout. Place a container under the spout and
pull the rubber plug from the spout. The water flows out, when the bowl is full, insert the plug,
empty the sump and drain the rest of the water.
If the condensation must be removed continuously, place the condensation drain hose (No. 16)
on the spout. Do remove the rubber plug. The condensate drain hose can be extended with
another hose (not supplied). It can be connected to a drain or be led outside. Make sure this
hose does not go up.
14
Use
Unplug the cord from the cord storage (No. 7) and plug into a grounded outlet
A
B
C
D
E
A Speed (ventilation) button
B Display
C Timer function button
D Sleep function button
E Compressor operation indicator
When pressing the on/off button (I), the device switches in the following mode:
Cooling fan low speed and a temperature of 24° C. Th e display (B) indicates the temperature of
the room (between 0° C and 50° C).
Cooling
Press the on/off button (I) and press the mode function button (F) to select the COOL mode,
the indicator COOL lights on, then. Set the desired temperature to the temperature setting
buttons, button G to set up the temperature and H button to set the temperature down.
The display will return to room temperature. If the temperature is below room temperature, the
compressor turns on and the device starts cooling. The compressor indicator (E) goes on. If
the desired temperature is reached, the fan still works but is the compressor and the
corresponding indicator (E) turn off again. With the speed button (A) select the desired fan
speed.
Fan function
Press the mode function button (F) and select the FAN mode, the LED FAN will light, then
press the on/off button (I). In FAN mode the device does not cool, the device is now used as a
fan.
F
G
H
I
J
F Mode function button
G Temperature up button
H Temperature down button
I On/Off power button
J Water full indicator
15