ProMinent DULCOMETER D2C Mode D'emploi page 26

Mounting / Installation
4.2.3 Control panel installation D2C W
A 4 mm wide flange acting as the stop for the control panel together with an all-round groove for a seal is
provided on the perimeter of the device. When mounted in a control panel, the entire front section
protrudes by approx. 35 mm from the control panel. The device is mounted from the outside in a prepared
aperture in the control panel. The device can be secured to the control panel from the inside with the
securing material provided.
Securing material for control panel installation:
• Item (1) 1x cellular rubber seal d3
• Item (2) 6x retaining bracket, galvanised steel
• Item (3) 6x PT self-tapping screw, galvanised
Procedure
Using the cut-out template provided, first mark the exact position of the device on the control panel.
Where possible, it should be positioned at eye-level. Ensure sufficient space is left at the top to allow for
the "park position". Mark and drill the corners. Hole diameter 12 - 13 mm.
IMPORTANT
Verify the actual dimensions of the drilling/punching template!
Now make the aperture as specified in the drawing with the aid of a punch or compass saw. The control
panel should be 2 - 3 mm thick. Before fitting the device in the aperture, evenly press the seal into the
groove on the outside of the housing. With the aid of a second person if necessary, the controller can then
be firmly secured with the retaining brackets and screws to the control panel.
26
Ø 8 x 50 deep drilled hole
3 4 2 1
D2C1(W) 003 D